Home › ENGINE ยท 1GR-FE › LUBRICATION › ENGINE OIL COOLER

ENGINE OIL COOLER > REMOVAL

for Preparation Click here



1. REMOVE V-BANK COVER


    A112983E03
  1. Remove the 2 nuts and V-bank cover.



2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    A151786E01

  1. Tighten the radiator drain cock plug by hand.



3. REMOVE OIL FILTER SUB-ASSEMBLY
  1. Remove the drain pipe cap.



    A134828E02
  1. Using SST, remove the oil filter.

    SST
    09228-07501  

    HINT:
    1. Put the disposal container beneath the drain hose to collect the oil from the oil filter cover.
    2. Drain hose inside diameter: 8 mm (0.315 in.)
    3. Drain hose length: 900 mm (2.95 ft.)



4. REMOVE OIL COOLER ASSEMBLY


    A151242
  1. Disconnect the oil cooler hose and No. 2 oil cooler hose from the oil cooler.



    A151243
  1. Remove the union bolt, plate washer and oil cooler.

  1. Remove the O-ring from the oil cooler.