Home › ENGINE ยท 1GR-FE › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY


A163050E01
SST
09820-63011   (09820-06010, 09820-06020)

HINT:
SST 1-A and B
09820-06010
SST 2
09820-06020

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured on the rotor shaft.



    A163051E01
  1. Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.



    A163052E01
  1. To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.

  1. Remove the generator from SST 2.



    A163053E01
  1. Turn SST 1-B, and remove SST 1-A and B.

  1. Remove the pulley nut and pulley.



2. REMOVE GENERATOR REAR END COVER


A163054
  1. Place the generator on the pulley.

  1. Remove the 3 nuts, then remove the rear end cover.



3. REMOVE TERMINAL INSULATOR


A163055


4. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


A163056
  1. Remove the 2 nuts, then remove the brush holder.



5. REMOVE GENERATOR COIL ASSEMBLY


A163057
  1. Remove the 4 bolts.



    A163058E01
  1. Using SST, remove the coil.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)



6. REMOVE GENERATOR ROTOR ASSEMBLY


A163059
  1. Remove the generator washer and the generator rotor.



7. REMOVE GENERATOR DRIVE END FRAME BEARING


    A163066
  1. Remove the 4 screws and retainer plate.



    A163067E01
  1. Using SST and a hammer, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)