Home › ENGINE ยท 1GR-FE › CHARGING › GENERATOR

GENERATOR > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR DRIVE END FRAME BEARING


    A163068E01
  1. Using SST and a press, press in a new bearing.

    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)



    A163066
  1. Install the retainer plate with the 4 screws.

    Torque:
    2.3 N*m{ 23 kgf*cm , 20 in.*lbf }



2. INSTALL GENERATOR ROTOR ASSEMBLY
  1. Place the drive end frame on the rotor.

  1. Install the rotor and washer.



3. INSTALL GENERATOR COIL ASSEMBLY


    A163069E01
  1. Using a 21 mm deep socket wrench and a press, push in the generator rectifier end frame carefully.



    A163057
  1. Install the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }



4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


    A163070E01
  1. While pushing the 2 brushes toward the inside of the brush holder, insert a pin (diameter: 1.0 mm (0.0394 in.)) into the brush holder hole.



    A163071E01
  1. Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull out the pin from the generator brush holder.



5. INSTALL TERMINAL INSULATOR


A163055
  1. Install the terminal insulator to the generator rectifier end frame.

    NOTICE:
    Pay attention to the mounting orientation of the terminal insulator.



6. INSTALL GENERATOR REAR END COVER
  1. Install the rear end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



7. INSTALL GENERATOR PULLEY


A163050E01
SST
09820-63011   (09820-06010, 09820-06020)

HINT:
SST 1-A and B
09820-06010
SST 2
09820-06020

  1. Install the pulley onto the rotor shaft by tightening the pulley nut by hand.

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured to the rotor shaft.



    A163051E01
  1. Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.



    A163072E01
  1. Tighten the pulley nut by turning SST 1-A in the direction shown in the illustration.

    Torque:
    133 N*m{ 1356 kgf*cm , 98 ft.*lbf }

  1. Remove the generator from SST 2.



    A163053E01
  1. Turn SST 1-B, and remove SST 1-A and B.

  1. Turn the pulley and check that the pulley moves smoothly.