Home › ENGINE · 1GR-FE › ENGINE MECHANICAL › DRIVE BELT

DRIVE BELT > INSTALLATION

for Preparation Click here



1. INSTALL FAN AND GENERATOR V BELT


    A076442E02
  1. While turning the belt tensioner counterclockwise, align the holes, and then insert a bar of φ 6 mm (0.236 in.) into the holes to fix the belt tensioner.



  1. Install the fan and generator V belt.

    HINT:
    A151277E01
    If it is hard to install the fan and generator V belt, perform the following procedures.
    1. Put the fan and generator V belt on all parts except the vane pump, as shown in the illustration.
    2. While releasing the belt tension by turning the belt tensioner counterclockwise, put the fan and generator V belt on the vane pump.

  1. While turning the belt tensioner counterclockwise, remove the bar.



2. INSTALL NO. 1 ENGINE UNDER COVER
  1. Install the engine under cover with the 5 bolts and 3 screws.

    Torque:
    for bolt:
    29 N*m{ 296 kgf*cm , 21 ft.*lbf }
    for screw:
    5.4 N*m{ 55 kgf*cm , 48 in.*lbf }



3. INSTALL V-BANK COVER


    A112983E02
  1. Install the V-bank cover with the 2 nuts.

    Torque:
    7.5 N*m{ 76 kgf*cm , 66 in.*lbf }