COMPRESSOR AND MAGNETIC CLUTCH (for 1GR-FE) > INSTALLATION |
| 1. ADJUST COMPRESSOR OIL |
When replacing the compressor and magnetic clutch with a new one, gradually discharge the refrigerant gas from the service valve, and drain the following amount of oil from the new compressor and magnetic clutch before installation.
| 2. INSTALL COOLER COMPRESSOR ASSEMBLY |
![]() |
Install the cooler compressor and 2 stud bolts.
Install the 2 bolts and 2 nuts.
| 3. CONNECT SUCTION HOSE |
![]() |
Remove the attached vinyl tape from the hose.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.
Install the O-ring on the cooler refrigerant suction hose.
Connect the cooler refrigerant suction hose on the cooler compressor with the bolt.
| 4. CONNECT DISCHARGE HOSE |
![]() |
Remove the attached vinyl tape from the hose.
Sufficiently apply compressor oil to a new O-ring and the fitting surface of the cooler compressor.
Install the O-ring on the cooler refrigerant discharge hose.
Connect the cooler refrigerant discharge hose on the cooler compressor with the bolt.
| 5. INSTALL FAN AND GENERATOR V BELT |
![]() |
While turning the belt tensioner counterclockwise, align the holes, and then insert a bar of φ 6 mm (0.236 in.) into the holes to fix the belt tensioner.
Install the fan and generator V belt.
![]() |
While turning the belt tensioner counterclockwise, remove the bar.
| 6. INSTALL FENDER APRON MUDGUARD SEAL LH |
![]() |
Install the seal with the 6 clips.
| 7. CHARGE REFRIGERANT |
Perform vacuum purging using a vacuum pump.
Charge refrigerant HFC-134a (R134a).

| 8. WARM UP ENGINE |
Warm up the engine at less than 1500 rpm for 1 minute or more after charging the refrigerant.
| 9. CHECK FOR REFRIGERANT GAS LEAK |
After recharging the refrigerant gas, check for refrigerant gas leakage using a halogen leak detector.
Perform the operation under the following conditions:
![]() |
Using a halogen leak detector, check the refrigerant line for leakage.
If a gas leak is not detected on the drain hose, remove the blower motor control (blower resistor) from the cooling unit. Insert the halogen leak detector sensor into the unit and perform the test.
Disconnect the connector and wait for approximately 20 minutes. Bring the halogen leak detector close to the pressure switch and perform the test.