Home › HEATER & AIR CONDITIONING SYSTEM › AIR CONDITIONING › COMPRESSOR AND MAGNETIC CLUTCH (for 2UZ-FE)

COMPRESSOR AND MAGNETIC CLUTCH (for 2UZ-FE) > REMOVAL

for Preparation Click here



1. RECOVER REFRIGERANT FROM REFRIGERATION SYSTEM
  1. Start up the engine.

  1. Turn the A/C switch ON.

  1. Operate the cooler compressor with an engine speed of approximately 1000 rpm for 5 to 6 minutes to circulate the refrigerant and collect the compressor oil remaining in each component into the cooler compressor.

  1. Stop the engine.

  1. Recover the refrigerant from the A/C system using a refrigerant recovery unit.



2. REMOVE FENDER APRON MUDGUARD SEAL LH


E143269
  1. Remove the 6 clips and seal.



3. REMOVE FAN AND GENERATOR V BELT


    B000809E02
  1. Loosen the belt tension by turning the belt tensioner counterclockwise, and then remove the fan and generator V belt.

    HINT:
    The pulley bolt for the belt tensioner has left-hand thread.



4. DISCONNECT DISCHARGE HOSE


    E142182
  1. Remove the bolt and disconnect the cooler refrigerant discharge hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant discharge hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



5. DISCONNECT SUCTION HOSE


    E142180
  1. Remove the bolt and disconnect the cooler refrigerant suction hose from the cooler compressor.

  1. Remove the O-ring from the cooler refrigerant suction hose.

    NOTICE:
    Seal the openings of the disconnected parts using vinyl tape to prevent moisture and foreign matter from entering them.



6. REMOVE COOLER COMPRESSOR ASSEMBLY


    E142184
  1. Disconnect the connector.

  1. Remove the 3 bolts, nut, cooler compressor and No. 1 compressor stay.