DTC Code
| DTC Detection Condition
| Trouble Area
|
01-D5*1, *3
| A device that the sub-code shows is (was) disconnected from the system when turning the ignition switch ON or ACC. The communication condition with the device that the code shows cannot be obtained when the engine starts.
| - Power source circuit of the component shown by the sub-code
- AVC-LAN circuit between the radio receiver and the component shown by the sub-code
- Component shown by the sub-code
|
01-D8*2, *3
| The device indicated by the sub-code is (was) disconnected from the system after the engine starts.
|
01-D9*1, *3
| The device that had functioned before the engine stopped is (was) disconnected from the system when turning the ignition switch ON or ACC.
|
01-DA*3
| No response is identified when changing mode. Sound and image do not change by switch operation.
|
01-DB*1, *3
| A dual alarm is detected.
|
01-DE*3, *4
| A slave device has been disconnected after the engine starts
|