Home › ENGINE ยท 2UZ-FE › CHARGING › GENERATOR

GENERATOR > DISASSEMBLY

for Preparation Click here



1. REMOVE GENERATOR PULLEY


A162627E01
SST
09820-63011   (09820-06010, 09820-06020)

HINT:
SST 1-A and B
09820-06010
SST 2
09820-06020

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured on the rotor shaft.



    B016524E04
  1. Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.



    A163073E01
  1. To loosen the pulley nut, turn SST 1-A in the direction shown in the illustration.

    NOTICE:
    To prevent damage to the rotor shaft, do not loosen the pulley nut more than one-half turn.

  1. Remove the generator from SST 2.



    A162628E01
  1. Turn SST 1-B, and remove SST 1-A and B.

  1. Remove the pulley nut and pulley.



2. REMOVE GENERATOR REAR END COVER


    A163074
  1. Place the generator on the pulley.

  1. Remove the 3 nuts and end cover.



    A163102
  1. Remove the terminal insulator.



3. REMOVE GENERATOR BRUSH HOLDER ASSEMBLY


    A163101
  1. Remove the 2 screws and brush holder.



4. REMOVE GENERATOR COIL ASSEMBLY


    A163046
  1. Remove the 4 bolts.



    A163047E01
  1. Using SST, remove the coil assembly.

    SST
    09950-40011   (09951-04020, 09952-04010, 09953-04020, 09954-04010, 09955-04071, 09957-04010, 09958-04011)

  1. Remove the generator washer.



5. REMOVE GENERATOR ROTOR ASSEMBLY


6. REMOVE GENERATOR DRIVE END FRAME BEARING


    B016375E01
  1. Remove the 4 screws and retainer plate.



    B016518E01
  1. Using SST and a hammer, tap out the bearing.

    SST
    09950-60010   (09951-00250)
    09950-70010   (09951-07100)