Home › ENGINE ยท 2UZ-FE › CHARGING › GENERATOR

GENERATOR > REASSEMBLY

for Preparation Click here



1. INSTALL GENERATOR DRIVE END FRAME BEARING


    B016515E01
  1. Using SST and a press, press in a new bearing.

    SST
    09950-60010   (09951-00470)
    09950-70010   (09951-07100)



    B016375E01
  1. Install the retainer plate with the 4 screws.

    Torque:
    2.3 N*m{ 23 kgf*cm , 20 in.*lbf }



2. INSTALL GENERATOR ROTOR ASSEMBLY


    A117223
  1. Place the drive end frame on the pulley.

  1. Install the rotor to the drive end frame.



3. INSTALL GENERATOR COIL ASSEMBLY


    A117224
  1. Place the generator washer on the rotor.



    B016512E01
  1. Using SST and a press, slowly press in the coil assembly.

    SST
    09285-76010  



    A163046
  1. Install the 4 bolts.

    Torque:
    5.8 N*m{ 59 kgf*cm , 51 in.*lbf }



4. INSTALL GENERATOR BRUSH HOLDER ASSEMBLY


    A163049E01
  1. While pushing the 2 brushes toward the inside of the brush holder, insert a pin (diameter 1.0 mm (0.0394 in.)) into the brush holder hole.



    A163103E01
  1. Install the generator brush holder with the 2 screws.

    Torque:
    1.8 N*m{ 18 kgf*cm , 16 in.*lbf }

  1. Pull out the pin from the generator brush holder.



5. INSTALL GENERATOR REAR END COVER


    A163102
  1. Install the terminal insulator to the generator rectifier end frame.

    NOTICE:
    Pay attention to the mounting orientation of the terminal insulator.



    B016513E01
  1. Install the end cover with the 3 nuts.

    Torque:
    4.6 N*m{ 47 kgf*cm , 41 in.*lbf }



6. INSTALL GENERATOR PULLEY


A162627E01
SST
09820-63011   (09820-06010, 09820-06020)

HINT:
SST 1-A and B
09820-06010
SST 2
09820-06020

  1. Install the pulley onto the rotor shaft by tightening the pulley nut by hand.

  1. Hold SST 1-A with a torque wrench, and tighten SST 1-B clockwise to the specified torque.

    Torque:
    39 N*m{ 398 kgf*cm , 29 ft.*lbf }

    NOTICE:
    Check that SST is secured to the rotor shaft.



    B016524E04
  1. Mount SST 2 in a vise.

  1. Insert SST 1-A and B into SST 2, and attach the pulley nut to SST 2.



    B016523E03
  1. Tighten the pulley nut by turning SST 1-A in the direction shown in the illustration.

    Torque:
    133 N*m{ 1356 kgf*cm , 98 ft.*lbf }

  1. Remove the generator from SST 2.



    A162628E01
  1. Turn SST 1-B, and remove SST 1-A and B.

  1. Turn the pulley and check that the pulley moves smoothly.