Home › BRAKE › BRAKE › REAR BRAKE

REAR BRAKE > DISASSEMBLY

for Preparation Click here



1. REMOVE REAR DISC BRAKE BLEEDER PLUG CAP


2. REMOVE REAR DISC BRAKE BLEEDER PLUG


3. REMOVE CYLINDER BOOT


    C155441
  1. Using a screwdriver, remove the cylinder boot from the cylinder.

    HINT:
    Tape the screwdriver tip before use.



4. REMOVE REAR DISC BRAKE PISTON


    C155442
  1. Place a piece of cloth or a similar object between the piston and cylinder.

  1. Use compressed air to remove the piston from the cylinder.

    CAUTION:
    Do not place your fingers in front of the piston when using compressed air.



5. REMOVE PISTON SEAL


    C155443
  1. Using a screwdriver, remove the piston seal from the cylinder.

    NOTICE:
    Do not damage the inner cylinder or cylinder groove.

    HINT:
    Tape the screwdriver tip before use.