Home › STEERING › POWER STEERING › VANE PUMP (for 1GR-FE)

VANE PUMP (for 1GR-FE) > INSPECTION

for Preparation Click here



1. INSPECT VANE PUMP SHAFT AND BUSH IN VANE PUMP FRONT HOUSING


    C132029E04
  1. Using a micrometer, measure the outer diameter [a] of the vane pump shaft.

  1. Using a vernier caliper, measure the inner diameter [b] of the vane pump front housing bush.

  1. Calculate the oil clearance.
    Oil clearance = Inner diameter of the bush [b] - Outer diameter of the shaft [a]

    Maximum oil clearance:
    0.07 mm (0.00276 in.)

    If the oil clearance exceeds the maximum, replace the vane pump assembly.



2. INSPECT VANE PUMP ROTOR AND VANE PUMP PLATE


    C101977E01
  1. Using a micrometer, measure the thickness of the vane pump plates.

    Standard thickness:
    1.405 to 1.411 mm (0.0553 to 0.0556 in.)

    If the thickness is not as specified, replace the vane pump assembly.



    C101978E01
  1. Using a feeler gauge, measure the clearance between the side face of the vane pump rotor groove and the vane pump plate.

    Maximum clearance:
    0.03 mm (0.00118 in.)

    If the clearance exceeds the maximum, replace the vane pump assembly.



3. INSPECT FLOW CONTROL VALVE ASSEMBLY


    C132030
  1. Coat the flow control valve with power steering fluid and check that it falls smoothly into the flow control valve by its own weight.
    If the control valve does not fall into the hole smoothly, replace the vane pump assembly.



    C132031
  1. Check the flow control valve for leakage. Close one of the holes and apply compressed air of 392 to 490 kPa (4.0 to 5.0 kgf/cm2, 57 to 71 psi) into the opposite side hole, and confirm that air does not come out from the end holes.
    If air leaks, replace the vane pump assembly.



4. INSPECT FLOW CONTROL VALVE COMPRESSION SPRING


    C132032
  1. Using a vernier caliper, measure the free length of the compression spring.

    Minimum free length:
    29.2 mm (1.15 in.)

    If the length is less than the minimum, replace the vane pump assembly.



5. INSPECT PRESSURE PORT UNION
  1. Visually check the pressure port union for fluid leaks. If there is a leak, replace the vane pump assembly.



6. INSPECT TOTAL PRELOAD
  1. Check that the pump rotates smoothly without abnormal noise.

  1. Temporarily install the service bolt.

    Recommended service bolt:
    Thread diameter:
    10 mm (0.394 in.)
    Thread pitch:
    1.25 mm (0.0492 in.)
    Bolt length:
    50 mm (1.97 in.)



    C053369E10
  1. Using a torque wrench, measure the pump rotating torque.

    Standard rotating torque:
    0.3 N*m (3 kgf*cm, 2 in.*lbf) or less

    If the rotating torque is not as specified, check the vane pump housing oil seal.