Home › BODY › WINDSHIELD / WINDOWGLASS › BACK POWER WINDOW SWITCH

BACK POWER WINDOW SWITCH > INSPECTION

for Preparation Click here



1. INSPECT POWER WINDOW REGULATOR SWITCH ASSEMBLY (for Back Window)


B169121E01
  1. Check the resistance.

    1. Measure the resistance according to the value(s) in the table below.

      Standard Resistance:
      Tester Connection
      Switch Condition
      Specified Condition
      Connector A-3 (UP) - Connector A-4 (E)
      UP
      Pressed
      Below 1 Ω
      Not pressed
      10 kΩ or higher
      Connector A-2 (DN) - Connector A-4 (E)
      DOWN
      Pressed
      Below 1 Ω
      Not pressed
      10 kΩ or higher

      If the result is not as specified, replace the power window regulator switch assembly.

  1. Check that the LED illuminates.

    1. Apply battery voltage to the power window regulator switch and check that the LED illuminates.

      OK:
      Measurement Condition
      Specified Condition
      Battery positive (+) → Connector A-5 (ILL+)
      Battery negative (-) → Connector A-1 (ILL-)
      LED illuminates

      If the result is not as specified, replace the power window regulator switch assembly.