Home › BRAKE › BRAKE CONTROL › VEHICLE STABILITY CONTROL SYSTEM

DTC    U0073/94    Control Module Communication Bus OFF

DTC    U0100/65    Lost Communication with ECM / PCM

DTC    U0114/27    Lost Communication with 4-Wheel Drive Clutch Control Module

DTC    U0123/62    Lost Communication with Yaw Rate Sensor Module

DTC    U0124/69    Deceleration Sensor Communication Circuit Malfunction

DTC    U0126/63    Lost Communication with Steering Angle Sensor Module

for Preparation Click here


DESCRIPTION

The skid control ECU exchanges signals with the ECM, steering angle sensor, yaw rate and deceleration sensor, power steering ECU, main body ECU and combination meter via CAN communication.

DTC Code
DTC Detection Conditions
Trouble Area
U0073/94
Bus off conditions continue for approximately 0.8 seconds.
CAN communication system
U0100/65
CAN signal from ECM is lost or malfunctioning for 1.2 seconds.
CAN communication system
U0114/27
CAN signal from 4WD control ECU is lost or malfunctioning for 1.2 seconds.
  1. CAN communication system
  2. 4WD control ECU
U0123/62
Supplied voltage normal (9.7 V or more), skid control ECU receives no yaw rate sensor data for 0.1 seconds.
  1. CAN communication system
  2. Yaw rate and deceleration sensor
U0124/69
Supplied voltage normal (9.7 V or more), skid control ECU receives no yaw rate sensor data for 0.1 seconds.
  1. CAN communication system
  2. Yaw rate and deceleration sensor
U0126/63
Supplied voltage normal (9.7 V or more), skid control ECU receives no steering angle sensor data for 0.1 seconds.
CAN communication system

INSPECTION PROCEDURE

1.RECONFIRM DTC
  1. Clear the DTC(s) (Click here).

  1. Check if the same DTC(s) is output (Click here).
    Result 
    Result
    Proceed to
    DTC is output
    A
    DTC is not output
    B



B
USE SIMULATION METHOD TO CHECK (Click here)
A

GO TO CAN COMMUNICATION SYSTEM (Click here)