Home › SUSPENSION & AXLE › AXLE › FRONT AXLE HUB

FRONT AXLE HUB > ON-VEHICLE INSPECTION

for Preparation Click here



1. REMOVE FRONT WHEEL


2. DISCONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    C154478
  1. Remove the 2 bolts and disc brake caliper from the knuckle.



3. REMOVE FRONT DISC


    C155464E01
  1. Put matchmarks on the front disc and axle hub if planning to reuse the disc.

  1. Remove the front disc.



4. REMOVE FRONT AXLE HUB GREASE CAP LH (for 4WD)


    C159317
  1. Using a screwdriver and hammer, remove the axle hub grease cap.

    NOTICE:
    Do not damage the axle hub.



5. INSPECT FRONT AXLE HUB BEARING LOOSENESS


    C159305
  1. Using a dial indicator, measure the looseness near the center of the axle hub.

    Maximum looseness:
    0.05 mm (0.00197 in.)

    NOTICE:
    Ensure that the dial indicator is set at a right angle to the measurement surface.

    If the looseness exceeds the maximum, replace the axle hub.



6. INSPECT FRONT AXLE HUB RUNOUT


    C160117
  1. Using a dial indicator, measure the runout on the surface of the axle hub outside the hub bolt.

    Maximum runout:
    0.03 mm (0.00118 in.)

    NOTICE:
    Ensure that the dial indicator is set at a right angle to the measurement surface.

    If the runout exceeds the maximum, replace the axle hub.



7. INSTALL FRONT AXLE HUB GREASE CAP LH (for 4WD)
  1. Install the axle hub grease cap.

    NOTICE:
    Make sure to securely fit the bearing to the axle hub.



8. INSTALL FRONT DISC


    C155464E01
  1. Align the matchmarks, and then install the front disc.

    HINT:
    When replacing the front disc with a new one, select the installation position where the front disc has the smallest runout.



9. CONNECT FRONT DISC BRAKE CALIPER ASSEMBLY LH


    C154478
  1. Install the disc brake caliper with 2 new bolts.

    Torque:
    99 N*m{ 1010 kgf*cm , 73 ft.*lbf }



10. INSTALL FRONT WHEEL

Torque:
for Aluminum Wheel:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
for Steel Wheel:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }