DTC B2797 Communication Malfunction No. 1 |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2797 | Keys are positioned too close to each other, or noise occurred in communication line |
|

| 1.CHECK KEY |
![]() |
Check whether the ignition key being used is near other ignition keys, as shown in the illustration. Also, check whether the key ring is in contact with the key grip.
| Result | Proceed to |
| Key is near other keys and/or key ring is in contact with key grip | A |
| Key is not near other keys and/or key ring is not in contact with key grip | B |
|
| ||||
| A | |
| 2.CHECK FOR DTC |
Separate the keys from each other, or remove the key ring.
Clear the DTC (Click here).
Insert a key into the ignition key cylinder. Remove it. Repeat for all other keys.
Check that no DTC is output (Click here).
|
| ||||
| OK | ||
| ||
| 3.CHECK TRANSPONDER KEY ECU (NOISE) |
![]() |
Using an oscilloscope or the intelligent tester, check for noise in the waveform between the terminals of the J20 amplifier connector and J26 ECU connector.
| Tester Connection | Tool Setting | Condition | Specified Condition |
| J26-15 (CODE) - J20-4 (CODE) | 5 V/DIV., 20 msec./DIV. | Key inserted in ignition key cylinder | No noise is present |
|
| ||||
| OK | |
| 4.CHECK HARNESS AND CONNECTOR (TRANSPONDER KEY ECU - TRANSPONDER KEY AMPLIFIER) |
![]() |
Disconnect the J26 ECU connector.
Disconnect the J20 amplifier connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J26-15 (CODE) - J20-4 (CODE) | Always | Below 1 Ω |
| J26-15 (CODE) or J20-4 (CODE) - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.REPLACE TRANSPONDER KEY AMPLIFIER |
Temporarily replace the transponder key amplifier with a new or normally functioning one (Click here).
| NEXT | |
| 6.CHECK WHETHER ENGINE STARTS |
Check that the engine starts normally.
|
| ||||
| OK | ||
| ||