DTC B2780 Push Switch / Key Unlock Warning Switch Malfunction |
| DTC Code | DTC Detection Condition | Trouble Area |
| B2780 | Unlock warning switch ON is not detected when the ignition switch is ON. |
|

| 1.CLEAR DTC |
Clear the DTC (Click here).
| NEXT | |
| 2.CHECK FOR DTC |
Check for DTC (Click here).
|
| ||||
| OK | ||
| ||
| 3.READ VALUE USING TECHSTREAM (UNLOCK WARNING SWITCH) |
Use the Data List to check if the unlock warning switch is functioning properly.
| Tester Display | Measurement Item/Range | Normal Condition | Diagnostic Note |
| Key SW | Unlock warning switch signal / ON or OFF | ON: Key is in ignition key cylinder OFF: No key is in ignition key cylinder | - |
|
| ||||
| OK | ||
| ||
| 4.INSPECT UNLOCK WARNING SWITCH |
![]() |
Remove the unlock warning switch (Click here).
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - 2 | Switch is pushed | Below 1 Ω |
| Switch is not pushed | 10 kΩ or higher |
|
| ||||
| OK | |
| 5.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - BODY GROUND) |
![]() |
Disconnect the J18 switch connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J18-2 - Body ground | Always | Below 1 Ω |
|
| ||||
| OK | |
| 6.CHECK HARNESS AND CONNECTOR (UNLOCK WARNING SWITCH - TRANSPONDER KEY ECU) |
![]() |
Disconnect the J18 switch connector.
Disconnect the J26 ECU connector.
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| J26-3 (KSW) - J18-1 | Always | Below 1 Ω |
| J26-3 (KSW) or J18-1 - Body ground | Always | 10 kΩ or higher |
|
| ||||
| OK | ||
| ||