DTC P0111 Intake Air Temperature Sensor 1 Circuit Range / Performance |

| DTC No. | DTC Detection Condition | Trouble Area |
| P0111 | When either condition below is met:
| Mass air flow meter assembly |
| Related DTCs | P0111: Intake air temperature sensor rationality (After engine stop) P0111: Intake air temperature sensor rationality (After cold engine start) |
| Required Sensors/Components (Main) | Intake Air Temperature (IAT) sensor |
| Required Sensors/Components (Sub) | - |
| Frequency of Operation | Once per driving cycle |
| Duration | 10 seconds or more |
| MIL Operation | 2 driving cycles |
| Sequence of Operation | None |
| Monitor runs whenever following DTCs are not present | P0102, P0103 (Mass Air Flow Sensor) P0115, P0117, P0118 (Engine Coolant Temperature Sensor) |
| Time after engine start | 10 seconds or more |
| Battery voltage | 10.5 V or more |
| ECT change since engine stop | -40°C (-40°F) or more |
| ECT before engine stop | 70°C (158°F) or more |
| Accumulated MAF amount before engine stop | 3240 g or more |
| Key-off duration | 30 minutes |
| Key-off duration | 5 hours |
| Time after engine start | 10 seconds or more |
| ECT | 70°C (158°F) or more |
| Accumulated MAF amount | 3240 g or more |
| Either of the following conditions 1 or 2 is met: | - |
| 1. Duration while engine load is low | 120 seconds or more |
| 2. Duration while engine load is high | 10 seconds or more |
| IAT change | Less than 1°C (2°F) |
| IAT change | Less than 1°C (2°F) |
| 1.CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P0111) |
Connect the Techstream to the DLC3.
Turn the ignition switch to ON.
Turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Trouble Codes.
Read DTCs.
| Display (DTC Output) | Proceed to |
| P0111 and other DTCs are output | A |
| P0111 is output | B |
|
| ||||
| A | ||
| ||