WIRELESS DOOR LOCK CONTROL SYSTEM > OPERATION CHECK |
| NOTICES WHEN CHECKING |
Wireless door LOCK / UNLOCK function:
This function operates only when the vehicle is in its initial condition (the following 3 conditions are met).
The wireless transmitter operating range differs depending on the situation.
| CHECK WIRELESS DOOR LOCK CONTROL FUNCTIONS |
Make sure the vehicle is in a condition in which the wireless control functions can be operated (see above).
Check the basic functions:
Check the chattering prevention function:
When a switch is pressed, check that the corresponding operation occurs only once. When the switch is held down, check that the corresponding operation occurs only once and does not repeatedly activate. Lastly, when the switch is pressed at 1 second intervals, check that the corresponding operation activates once for each press of the switch.
Check the automatic locking function:
When all doors are unlocked with the UNLOCK switch and none of the doors are opened or locked within 30 seconds, check that the doors are relocked automatically.
Check the switch operation fail-safe function:
If the key is in the ignition key cylinder, check that the doors cannot be locked by the LOCK switch. However, this does not apply when the system is in recognition code registration mode.
Check the door ajar warning function:
If a door is open or not completely closed, check that the doors cannot be locked by the LOCK switch and that the wireless door lock buzzer sounds for 10 seconds.
Check the answer-back function:
Check the illuminated entry function:
Check the panic function:
Check that if the PANIC switch is held down for 1 second or more, the theft deterrent alarm function sounds the vehicle horns and security horn, flashes the door mirror turn signal indicators, headlights, taillights and hazard warning lights, and illuminates the map light and room light for 60 seconds. With the theft alarm function active, check that pressing any switch on the transmitter causes the theft alarm function to stop.