Home › BODY ELECTRICAL › DOOR LOCK › WIRELESS DOOR LOCK CONTROL SYSTEM

WIRELESS DOOR LOCK CONTROL SYSTEM > TERMINALS OF ECU

for Preparation Click here



CHECK MAIN BODY ECU (DRIVER SIDE JUNCTION BLOCK)

E146648E03

  1. Disconnect the DD and DB ECU connectors.

  2. Measure the resistance and voltage according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    DD-62 (GND1) - Body ground
    W-B - Body ground
    Ground
    Always
    Below 1 Ω
    DB-13 (BECU) - DD-62 (GND1)
    GR - W-B
    BECU power supply
    Always
    11 to 14 V
    If the result is not as specified, there may be a malfunction in the wire harness side.

  3. Reconnect the DD and DB ECU connectors.

  4. Measure the voltage and resistance according to the value(s) in the table below.

    Terminal No. (Symbols)
    Wiring Color
    Terminal Description
    Condition
    Specified Condition
    J1-5 (KSW) - DD-62 (GND1)
    LG - W-B
    Key unlock warning switch signal
    Key inserted in the ignition key cylinder
    Below 1 Ω
    No key in the ignition key cylinder
    10 kΩ or higher
    J4-24 (DCTY) - Body ground
    BR - Body ground
    Front door courtesy light switch LH signal
    Front door LH open
    Below 1 V
    Front door LH closed
    Pulse generation
    J3-21 (PCTY) - Body ground
    BE - Body ground
    Front door courtesy light switch RH signal
    Front door RH open
    Below 1 V
    Front door RH closed
    Pulse generation
    DC-2 (LCTY) - Body ground*1, *2
    B - Body ground
    Rear door courtesy light switch LH signal
    Rear door LH open
    Below 1 V
    Rear door LH closed
    Pulse generation
    J3-25 (RRCY) - Body ground*1, *2
    L - Body ground
    Rear door courtesy light switch RH signal
    Rear door RH open
    Below 1 V
    Rear door RH closed
    Pulse generation
    DD-53 (L2) - Body ground
    V - Body ground
    Front door lock key switch LH input
    Front door key cylinder LH to LOCK
    Pulse generation
    Ignition switch OFF, all doors closed and front door key cylinder LH to neutral position
    Below 1 V
    J4-10 (UL3) - Body ground
    B - Body ground
    Front door lock key switch LH input
    Front door key cylinder LH to UNLOCK
    Pulse generation
    Ignition switch OFF, all doors closed and front door key cylinder LH to neutral position
    Below 1 V
    J4-5 (ACTD) - Body ground
    P - Body ground
    Front door lock motor LH unlock activation output
    Master switch (door control switch) or front door key cylinder LH to LOCK
    Below 1 V
    Master switch (door control switch) or front door key cylinder LH to UNLOCK
    Pulse generation
    DD-3 (ACT+) - Body ground
    W - Body ground
    Door lock motor lock activation output
    Master switch (door control switch) or front door key cylinder LH to UNLOCK
    Below 1 V
    Master switch (door control switch) or front door key cylinder LH to LOCK
    Pulse generation
    J4-9 (LSWD) - Body ground
    P - Body ground
    Front door unlock detection switch LH input
    Front door LH UNLOCK
    Below 1 V
    Front door LH LOCK
    Pulse generation
    DD-2 (ACT-) - Body ground
    L - Body ground
    Door lock motor unlock activation output
    Master switch (door control switch) or front door key cylinder LH to LOCK
    Below 1 V
    Master switch (door control switch) or front door key cylinder LH to UNLOCK
    Pulse generation
    DC-24 (ACT+) - Body ground*1, *2
    W - Body ground
    Rear door lock motor LH lock activation output
    Master switch (door control switch) or front door key cylinder LH to UNLOCK
    Below 1 V
    Master switch (door control switch) or front door key cylinder LH to LOCK
    Pulse generation
    DC-23 (ACT-) - Body ground*1, *2
    L - Body ground
    Rear door lock motor LH unlock activation output
    Master switch (door control switch) or front door key cylinder LH to UNLOCK
    Below 1 V
    Master switch (door control switch) or front door key cylinder LH to LOCK
    Pulse generation
    J3-27 (LSWP) - Body ground
    V - Body ground
    Front door unlock detection switch RH input
    Front door RH UNLOCK
    Below 1 V
    Front door RH LOCK
    Pulse generation
    DC-1 (LSWL) - Body ground*1, *2
    GR - Body ground
    Rear door unlock detection switch LH input
    Rear door LH UNLOCK
    Below 1 V
    Rear door LH LOCK
    Pulse generation
    J3-5 (LSWR) - Body ground*1, *2
    Y - Body ground
    Rear door unlock detection switch RH input
    Rear door RH UNLOCK
    Below 1 V
    Rear door RH LOCK
    Pulse generation
    J3-10 (PRG) - Body ground
    SB - Body ground
    Door control receiver output
    Transmitter switch ON → OFF (No key in ignition key cylinder, all doors closed)
    Pulse generation
    J3-12 (RDA) - Body ground
    V - Body ground
    Door control receiver input
    Transmitter switch ON → OFF (No key in ignition key cylinder, all doors closed)
    Pulse generation
    J2-4 (HAZ) - Body ground
    BE - Body ground
    Hazard warning light signal
    Answer-back ON
    Pulse generation
    Answer-back OFF
    Below 1 V
    J1-7 (BZR) - Body ground
    R - Body ground
    Wireless door lock buzzer signal
    Answer-back ON
    Pulse generation
    Answer-back OFF
    Below 1 V
    J1-6 (SH) - Body ground
    W - Body ground
    Security horn signal
    Panic switch OFF
    Below 1 V
    Panic switch ON
    Pulse generation
    DB-1 (HORN) - Body ground
    V - Body ground
    Vehicle's horn signal
    Panic switch OFF
    Below 1 V
    Panic switch ON
    Pulse generation

    HINT:
    1. *1: for Double Cab
    2. *2: for CrewMax

    If the result is not as specified, the main body ECU may have a malfunction.