Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › REAR VIEW MONITOR SYSTEM

REAR VIEW MONITOR SYSTEM > Display Signal Circuit between Navigation Receiver Assembly and Television Camera Assembly

for Preparation Click here


DESCRIPTION

This is the display signal circuit between the navigation receiver assembly and the television camera.

WIRING DIAGRAM


E146509E02


INSPECTION PROCEDURE

1.CHECK HARNESS AND CONNECTOR (NAVIGATION RECEIVER ASSEMBLY - TELEVISION CAMERA)

E146510E02

  1. Disconnect the K7 navigation receiver assembly connector.

  1. Disconnect the X1 camera connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Connection
    Condition
    Specified Condition
    K7-22 (V+) - X1-1 (CV+)
    Always
    Below 1 Ω
    K7-23 (V-) - X1-2 (CV-)
    Always
    Below 1 Ω
    K7-21 (CGND) - X1-4 (CGND)
    Always
    Below 1 Ω
    K7-24 (CA+) - X1-3 (CB+)
    Always
    Below 1 Ω
    K7-22 (V+) - Body ground
    Always
    10 kΩ or higher
    K7-23 (V-) - Body ground
    Always
    10 kΩ or higher
    K7-21 (CGND) - Body ground
    Always
    10 kΩ or higher
    K7-24 (CA+) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK


2.CHECK NAVIGATION RECEIVER ASSEMBLY

E146511E02

  1. Disconnect the X1 camera connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    X1-3 (CB+) - X1-4 (CGND)
    Ignition switch ON, shift lever R position
    5.5 to 7.05 V

    Result 
    Result
    Proceed to
    OK
    A
    NG (for Column Shift Type)
    B
    NG (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
A


3.CHECK TELEVISION CAMERA ASSEMBLY

E146512E02

  1. Reconnect the X1 camera connector.



    E119731E01
  1. Using an oscilloscope, check the waveform.
    Waveform (Reference) 
    Item
    Content
    Tester Connection
    X1-1 (CV+) - X1-2 (CV-)
    Tool Setting
    0.2 V/DIV., 0.2 μsec./DIV.
    Condition
    Ignition switch ON, shift lever R position

    OK:
    Correct waveform is as shown.

    Result 
    Result
    Proceed to
    NG
    A
    OK (for Column Shift Type)
    B
    OK (for Floor Shift Type)
    C



B
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)

C
REPLACE NAVIGATION RECEIVER ASSEMBLY (Click here)
A

REPLACE TELEVISION CAMERA ASSEMBLY (Click here)