Home › ENGINE ยท 2UZ-FE › FUEL › FUEL INJECTOR

FUEL INJECTOR > INSPECTION

for Preparation Click here



1. INSPECT INJECTION VOLUME AND LEAKAGE


  1. Check the injector injection.

    CAUTION:
    1. This test involves high-pressure fuel and electricity.
    2. Take every precaution regarding safe handling of both the fuel and the electrical parts.
    3. Perform this test in a safe area, and avoid any sparks or flame.
    4. Do not smoke.




      A159813E01
    1. Assemble SST as shown in the illustration.

      SST
      09268-31011   (95336-08070, 09268-41091, 09268-41110, 09268-41300, 09268-41500)

    2. Discharge the fuel system pressure (Click here).

    3. Disconnect the fuel inlet hose (fuel tube connector) from the No. 1 fuel pipe.

    4. Remove the bolt and disconnect the fuel pressure regulator from the fuel delivery pipe.

      NOTICE:
      Do not disconnect the No. 2 fuel hose from the fuel pressure regulator.



    5. A158335E01
    6. Connect SST to the No. 1 fuel pipe.

      CAUTION:
      Always read the precautions before connecting the fuel tube connector.



    7. A133773E01
    8. Connect SST (hose) to the fuel inlet of the pressure regulator with another SST (union), O-ring and the 2 bolts.

      Torque:
      7.5 N*m{ 77 kgf*cm , 66 in.*lbf }

    9. Connect the fuel return hose to the fuel outlet of the pressure regulator.



    10. A133660E01
    11. Install the O-ring to the injector.

    12. Connect SSTs (adaptor and hose) to the injector, and hold the injector and union with another SST (clamp).

      SST
      09268-31011   (95336-08070, 09268-41110, 09268-41300)

    13. Put the injector into a graduated cylinder.

      CAUTION:
      Install a suitable vinyl hose onto the injector to prevent gasoline from splashing out.

    14. Connect the Techstream to the DLC3.

    15. Operate the fuel pump .



    16. A133661E01
    17. Connect SST (wire) to the injector and battery for 15 seconds, and measure the injection volume with the graduated cylinder. Test each injector 2 or 3 times.

      SST
      09842-30070  

      Standard volume:
      Injection volume
      Difference between each injector
      56 to 69 cm3 (3.4 to 4.2 cu in.) per 15 seconds
      13 cm3 (0.8 cu in.) or less

      If the injection volume is not as specified, replace the injector.



  1. Check for fuel leak.



      A133662E01
    1. In the condition above, disconnect the tester probes of SST (wire) from the battery and check for fuel leak from the injector.

      SST
      09842-30070  

      Fuel leak:
      1 drop or less per 12 minutes

    2. Turn the ignition switch OFF.

    3. Disconnect the cable from the negative (-) battery terminal.

    4. Remove SST and fuel tube connector.

      SST
      09842-30070  

    5. Disconnect the Techstream from the DLC3.

    6. Reconnect the fuel inlet pipe to the fuel tube.