AIR PUMP (for Bank 1) > INSPECTION |
| 1. INSPECT AIR PUMP |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| 1 - 2 | 20°C (68°F) | 0.4 to 1.0 Ω |
| 1 - Body ground | Always | 10 kΩ or higher |
| 2 - Body ground |
![]() |
Check operation of the air pump.
Check that air does not flow from port A to port B.
If the result is not as specified, replace the air pump.
![]() |
Apply battery voltage across terminals 1 and 2.
Check that air flows from port A to port B.
If the result is not as specified, replace the air pump.