EMISSION CONTROL SYSTEM > ON-VEHICLE INSPECTION |
| 1. INSPECT FUEL CUT-OFF RPM |
Start and warm up the engine.
Open the throttle valve and keep the engine speed at 3000 rpm.
Use a sound scope to check for injector operating noise.
Check that when the accelerator pedal is released, injector operation noise stops momentarily and then resumes.
If the result is not specified, check the injector, wiring and ECM.
| 2. VISUALLY INSPECT HOSES, CONNECTIONS AND GASKETS |
![]() |
Check that there are no cracks, leaks or damage.
| 3. INSPECT FUEL CUT-OFF VALVE AND FILL CHECK VALVE |
![]() |
Disconnect the vent line hose from the fuel tank.
Connect the pressure gauge to the fuel tank.
Fill the fuel tank with fuel.
Apply pressure of 4 kPa (0.04 kgf/cm2, 0.58 psi) to the vent port of the fuel tank.
Remove the fuel tank cap, and check that the pressure inside the tank drops.
If pressure does not drop, replace the fuel tank assembly.
Reconnect the vent line hose to the fuel tank.
| 4. CHECK AIR INLET LINE |
![]() |
Disconnect the air inlet line hose from the canister.
Check that there is ventilation in the air inlet line.
Reconnect the air inlet line hose to the canister.
| 5. INSPECT PRESSURE SENSOR |
![]() |
Connect a pressure gauge to the air pressure sensor as shown in the illustration.
Connect the Techstream to the DLC3.
Turn the ignition switch to ON and turn the Techstream ON.
Enter the following menus: Powertrain / Engine and ECT / Data List / All Data / Air pump pressure (absolute) and Air pump2 pressure (absolute).
Check that the pressure displayed on the tester fluctuates when applying pressure to the pressure sensor with the pressure gauge.
![]() |
Check the power source voltage.
Disconnect the connector.
Turn the ignition switch to ON.
Measure the voltage according to the value(s) in the table below.
| Tester Connection | Condition | Specified Condition |
| for Bank 1: 2 (VC) - 4 (E2) | Ignition switch ON | 4.75 to 5.25 V |
| for Bank 2: 2 (VC2) - 4 (E22) |