Home › ENGINE ยท 2UZ-FE › LUBRICATION › OIL PUMP

OIL PUMP > REASSEMBLY

for Preparation Click here



1. INSTALL OIL PUMP ROTOR SET


    A150121
  1. Place the drive and driven rotors into the pump body with the marks facing the pump body cover side.



    A150119
  1. Install the oil pump cover with the 10 screws.

    Torque:
    10 N*m{ 102 kgf*cm , 7 ft.*lbf }



2. INSTALL OIL PUMP RELIEF VALVE


    A160767
  1. Insert the relief valve and compression spring into the oil pump body hole.

  1. Install the plug.

    Torque:
    49 N*m{ 500 kgf*cm , 36 ft.*lbf }



3. INSTALL FRONT CRANKSHAFT OIL SEAL


    A134819E02
  1. Using SST and a hammer, tap in a new oil seal until its surface is flush with the oil pump body edge.

    SST
    09316-60011   (09316-00011)

    NOTICE:
    1. Keep the lip free from foreign matter.
    2. Do not tap oil seal at an angle.

  1. Apply MP grease to the oil seal lip.