ENGINE OIL COOLER > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.
Remove the radiator cap. Then drain the coolant.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 3. DRAIN ENGINE OIL |
![]() |
Remove the oil filler cap.
Remove the oil drain plug and gasket, and drain the engine oil into a container.
| 4. REMOVE OIL FILTER ASSEMBLY |
![]() |
Using SST, remove the oil filter.
| 5. REMOVE OIL COOLER ASSEMBLY |
![]() |
Disconnect the 2 oil cooler hoses from the oil cooler.
Remove the union bolt, plate washer and oil cooler.
![]() |
Remove the O-ring from the oil cooler.