THERMOSTAT > REMOVAL |
| 1. REMOVE NO. 1 ENGINE UNDER COVER |
![]() |
Remove the 3 screws and 5 bolts.
Unhook the engine under cover from the vehicle body as shown in the illustration.
| 2. DRAIN ENGINE COOLANT |
Loosen the radiator drain cock plug.
Remove the radiator cap. Then drain the coolant from the radiator.
Loosen the 2 cylinder block drain cock plugs. Then drain the coolant from the engine.
Tighten the 2 cylinder block drain cock plugs.

Tighten the radiator drain cock plug by hand.
| 3. REMOVE V-BANK COVER SUB-ASSEMBLY |
![]() |
Raise the front of the V-bank cover to detach the 2 pins. Then remove the 2 V-bank cover hooks from the bracket, and remove the V-bank cover.
| 4. DISCONNECT OUTLET RADIATOR HOSE |
| 5. REMOVE WATER INLET SUB-ASSEMBLY WITH THERMOSTAT |
![]() |
Disconnect the No. 2 and No. 3 air hoses.
Disconnect the air pump connector.
Disconnect the air pump connector clamp's holder.
Using a clip remover, detach the wire harness clamp.
![]() |
Disconnect the No. 5 water by-pass hose.
Remove the air tube bracket bolt.
![]() |
Remove the 3 nuts, water inlet with thermostat and gasket.