Home › ENGINE ยท 1GR-FE › COOLING › RADIATOR

RADIATOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER
  1. Remove the 5 bolts, 3 screws and engine under cover.



2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 133 kgf*cm , 10 ft.*lbf }



    A151786E01

  1. Tighten the radiator drain cock plug by hand.



3. REMOVE V-BANK COVER


    A112983E03
  1. Remove the 2 nuts and V-bank cover.



4. DISCONNECT RADIATOR HOSE INLET


5. DISCONNECT RADIATOR HOSE OUTLET


6. REMOVE FAN SHROUD


    A134581
  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the fan and generator V-belt (Click here).



    A151755
  1. Disconnect the reservoir hose from the radiator tank upper.

  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.



7. REMOVE RADIATOR SIDE DEFLECTOR RH


    A151775
  1. Using a clip remover, remove the 6 clips and side deflector.



8. REMOVE RADIATOR SIDE DEFLECTOR LH


    A151774
  1. Remove the wire harness clamp.

  1. Using a clip remover, remove the 6 clips and side deflector.



9. REMOVE RADIATOR ASSEMBLY


    A151751
  1. Remove the 4 bolts and radiator.