Home › ENGINE ยท 2UZ-FE › COOLING › RADIATOR

RADIATOR > REMOVAL

for Preparation Click here



1. REMOVE NO. 1 ENGINE UNDER COVER


    A150108
  1. Remove the 3 screws and 5 bolts.

  1. Unhook the engine under cover from the vehicle body as shown in the illustration.



2. DRAIN ENGINE COOLANT

CAUTION:
Do not remove the radiator cap while the engine and radiator are still hot. Pressurized, hot engine coolant and steam may be released and cause serious burns.

  1. Loosen the radiator drain cock plug and 2 cylinder block drain cock plugs.

  1. Remove the radiator cap. Then drain the coolant.

    HINT:
    Collect the coolant in a container and dispose of it according to the regulations in your area.



  1. Tighten the 2 cylinder block drain cock plugs.

    Torque:
    13 N*m{ 130 kgf*cm , 10 ft.*lbf }



    A156211E01

  1. Tighten the radiator drain cock plug by hand.



3. DISCONNECT NO. 1 OIL COOLER INLET HOSE AND NO. 1 OIL COOLER OUTLET HOSE (w/ Trailer Towing System)
  1. Disconnect the 2 oil cooler hoses.



    A156207
  1. Detach the claw to open the flexible hose clamp.



4. REMOVE FRONT BUMPER COVER (w/ Trailer Towing System)
  1. For resin type, refer to the following procedures (Click here).

  1. Except resin type, refer to the following procedures (Click here).



5. REMOVE RADIATOR SIDE DEFLECTOR LH


    A151774
  1. Using a clip remover, remove the 6 clips.

  1. Remove the wire harness clamp.



6. REMOVE RADIATOR SIDE DEFLECTOR RH (w/o Trailer Towing System)


    A151775
  1. Using a clip remover, remove the 6 clips.



7. REMOVE OIL COOLER ASSEMBLY (w/ Trailer Towing System)


    C155880
  1. Remove the 3 bolts and oil cooler.



    C155881
  1. Remove the 2 bolts and oil cooler support.

  1. Remove the 4 bolts and separate the No. 1 and No. 2 oil cooler air ducts.



8. REMOVE THROTTLE BODY COVER SUB-ASSEMBLY


    A156183E01
  1. Remove the 2 cap nuts and throttle body cover.



    A156184E02
  1. Remove the 2 bolts and 2 throttle body cover brackets from the intake manifold.



9. REMOVE AIR CLEANER HOSE ASSEMBLY


    A153487
  1. Disconnect the vacuum hose and No. 2 ventilation hose.

  1. Loosen the 2 hose clamps.

  1. Remove the air cleaner hose.



10. REMOVE RADIATOR HOSE INLET


11. REMOVE FAN SHROUD


    A162053
  1. Loosen the 4 nuts holding the fluid coupling fan.

  1. Remove the fan and generator V-belt.

  1. Disconnect the reservoir hose from the radiator tank upper.



    A156168
  1. Remove the 2 bolts holding the fan shroud.

  1. Remove the 4 nuts of the fluid coupling fan, and then remove the shroud together with the coupling fan.

    NOTICE:
    Be careful not to damage the radiator core.

  1. Remove the fan pulley from the water pump.



12. REMOVE RADIATOR HOSE OUTLET


13. REMOVE RADIATOR ASSEMBLY


    A156166
  1. Remove the 4 bolts and radiator.