Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Park / Neutral Position Switch Circuit

for Preparation Click here


DESCRIPTION

This circuit sends the park / neutral position switch signals to the clearance warning ECU.

WIRING DIAGRAM


B144584E02


INSPECTION PROCEDURE

1.INSPECT PARK / NEUTRAL POSITION SWITCH
E146355E01
  1. Disconnect the D35 switch connector.

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Condition
    Condition
    Specified Condition
    6 (PL) - 2 (RB)
    Shift lever on P
    Below 1 Ω
    1 (RL) - 2 (RB)
    Shift lever on R
    Below 1 Ω
    6 (PL) - 2 (RB)
    Shift lever not on P
    10 kΩ or higher
    1 (RL) - 2 (RB)
    Shift lever not on R
    10 kΩ or higher

    Result 
    Result
    Proceed to
    OK
    A
    NG (for A750E)
    B
    NG (for A750F)
    C



B
REPLACE PARK / NEUTRAL POSITION SWITCH (Click here)

C
REPLACE PARK / NEUTRAL POSITION SWITCH (Click here)
A


2.CHECK HARNESS AND CONNECTOR (SWITCH - CLEARANCE WARNING ECU AND BATTERY)
B144078E02
  1. Disconnect the D35 switch connector.

  1. Disconnect the J35 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Condition
    Switch Condition
    Specified Condition
    D35-2 (RB) - Body ground
    Ignition switch ON
    11 to 14 V

  1. Measure the resistance according to the value(s) in the table below.

    Standard resistance:
    Tester Condition
    Condition
    Specified Condition
    D35-6 (PL) - J35-1 (PL)
    Always
    Below 1 Ω
    D35-1 (RL) - J35-13 (RL)
    Always
    Below 1 Ω
    D35-6 (PL) - Body ground
    Always
    10 kΩ or higher
    D35-1 (RL) - Body ground
    Always
    10 kΩ or higher



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)