Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › CYLINDER BLOCK

CYLINDER BLOCK > DISASSEMBLY

for Preparation Click here



1. INSPECT CONNECTING ROD THRUST CLEARANCE


    A075147E01
  1. Using a dial indicator, measure the thrust clearance while moving the connecting rod back and forth.

    Standard thrust clearance:
    0.15 to 0.30 mm (0.00591 to 0.0118 in.)

    Maximum thrust clearance:
    0.35 mm (0.0138 in.)

    If the thrust clearance is greater than the maximum, replace one or more connecting rods as necessary.
    If necessary, replace the crankshaft.



2. REMOVE PISTON SUB-ASSEMBLY WITH CONNECTING ROD


    A076043E01
  1. Using a ridge reamer, remove all the carbon from the top of the cylinder.

  1. Uniformly loosen the connecting rod bolts, and remove the connecting rod cap with bearing.

  1. Push out the piston with connecting rod and upper bearing through the top of the cylinder block.

    HINT:
    1. Keep the bearings, connecting rod and cap together.
    2. Arrange the piston and connecting rod assemblies in the correct order.



3. REMOVE CONNECTING ROD BEARING


4. REMOVE PISTON RING SET


    A076044E01
  1. Using a piston ring expander, remove the 2 compression rings.

  1. Remove the 2 side rails and oil ring (expander) by hand.



5. REMOVE PISTON PIN HOLE SNAP RING


    P012403E01
  1. Using a screwdriver, pry out the 2 snap rings.



6. REMOVE PISTON WITH PIN SUB-ASSEMBLY


    A076045E08
  1. Gradually heat the piston to approximately 80°C (176°F).



    A076046E01
  1. Using a plastic-faced hammer and brass bar, lightly tap out the piston pin and remove the connecting rod.

    HINT:
    1. The piston and pin are a matched set.
    2. Arrange the pistons, pins, rings, connecting rods and bearings in the correct order.



7. INSPECT CRANKSHAFT THRUST CLEARANCE


    A076047E01
  1. Using a dial indicator, measure the thrust clearance while prying the crankshaft back and forth with a screwdriver.

    Standard thrust clearance:
    0.04 to 0.24 mm (0.00157 to 0.00945 in.)

    Maximum thrust clearance:
    0.30 mm (0.0118 in.)

    If the thrust clearance is greater than the maximum, replace the thrust washers as a set.

    Standard thrust washer thickness:
    1.93 to 1.98 mm (0.0760 to 0.0780 in.)

    If necessary, replace the crankshaft.



8. REMOVE CRANKSHAFT


    A076048E03
  1. Using several steps, loosen and remove the 8 bearing cap bolts and seal washers uniformly in the sequence shown in the illustration.



    A076049E03
  1. Using several steps, loosen and remove the 16 bearing cap bolts uniformly in the sequence shown in the illustration.



    A076050E01
  1. Using a screwdriver, pry out the bearing caps. Remove the 4 bearing caps and lower bearings.

    NOTICE:
    1. Push up on the cap little by little, alternating from the right and left side until the cap can be removed.
    2. Be careful not to damage the joint surfaces of the cylinder block and the bearing cap.



9. REMOVE CRANKSHAFT THRUST WASHER SET


10. REMOVE CRANKSHAFT


11. REMOVE CRANKSHAFT BEARING


12. REMOVE NO. 1 OIL NOZZLE SUB-ASSEMBLY


    A076051E01
  1. Using a 5 mm hexagon socket wrench, remove the 3 bolts and 3 oil nozzles.