Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › CYLINDER HEAD

CYLINDER HEAD > REASSEMBLY

for Preparation Click here



1. INSTALL VALVE STEM OIL SEAL

HINT:
The intake valve stem oil seal is light brown and the exhaust valve stem oil seal is gray.



    A094934E06
  1. Apply a light coat of engine oil to the valve stem oil seal.



    A075639E01
  1. Using SST, push in a new valve stem oil seal.

    SST
    09201-41020  



2. INSTALL VALVE SPRING SEAT


    A075638E01
  1. Install the valve spring seat.



3. INSTALL VALVE


    A075640E02
  1. Apply plenty of engine oil to the tip area of the exhaust valve shown in the illustration.



    A075602E03
  1. Place the cylinder head on a wooden block.

  1. Install the valve, inner compression spring and valve spring retainer to the cylinder head.

    NOTICE:
    Install the same parts in the same combination to their original locations.

  1. Using SST, compress the inner compression spring and place the valve spring retainer lock around the valve stem.

    SST
    09202-70020   (09202-00010)



    A075641E01
  1. Using a pin punch 5, lightly tap the valve stem tip to ensure a proper fit.

    NOTICE:
    Be careful not to damage the valve stem tip.



4. INSTALL VALVE LIFTER


    A075601E01
  1. Apply engine oil to the valve stem end and valve lifter, and install the valve lifter to the valve stem.

  1. Check that the valve lifter rotates smoothly by hand.