AUTOMATIC TRANSMISSION FLUID > ADJUSTMENT |
| 1. PRELIMINARY PROCEDURES |
![]() |
w/ Trailer Towing System (w/ Transmission oil cooler thermostat):
Using compressed air, etc., blow dust off the thermostat cap to clean it.
Using a screwdriver, push the shaft of the thermostat.
With the shaft of the thermostat pressed, push a pin into a hole on the side of the thermostat's cap. Insert the pin until it passes through the hole on the other side of the thermostat's cap to fix the shaft in place.
| 2. BEFORE FILLING TRANSMISSION |
| 3. TRANSMISSION FILL |
![]() |
Remove the refill plug and overflow plug.
![]() |
Fill the transmission through the refill hole until fluid begins to trickle out of the overflow tube.
Reinstall the overflow plug.
Fill the transmission with the amount of fluid listed in the table below.
| Repair | Fill Amount |
| Transmission pan and drain plug removal | 1.7 liters (1.8 US qts, 1.5 Imp. qts) |
| Transmission valve body removal | 4.3 liters (4.5 US qts, 3.8 Imp. qts) |
| Torque converter removal | 5.4 liters (5.7 US qts, 4.8 Imp. qts) |
Install the refill plug.
Start the engine to idle.
Move the shift lever through the entire gear range to circulate the fluid.
Wait for 30 seconds with the engine idling.
Stop the engine.
Remove the refill plug.
Fill the transmission with the remaining fluid until the amount in the table has been filled.
Install the refill plug.
| 4. FLUID TEMPERATURE CHECK |
Turn the ignition switch off.
Connect the Techstream to the DLC3.
Turn the ignition switch ON.
Enter the following menus: Powertrain / ECT / Data List / A/T Oil Temperature 1.
Check the ATF temperature.
| 5. FLUID LEVEL CHECK |
Enter the following menus: Powertrain / ECT / Active Test / Connect the TC and TE1.
![]() |
Start the engine to idle.
Slowly move the shift lever from P to S, then change the gear from 1st to 5th. Then return the shift lever to P.
![]() |
Move the shift lever to D, and quickly move back and forth between N and D (once within 1.5 seconds) for at least 6 seconds. This will activate the fluid temperature detection mode.
Return the shift lever to P and terminate the Active Test on the Techstream.
Using the Techstream, allow the engine to idle until the fluid temperature reaches 36 to 46°C (97 to 115°F).
| Below 36°C (97°F) | 36 to 46°C (97 to 115°F) | Exceed 46°C (115°F) |
| Turn off | Turn on | Blinking |
![]() |
Remove the overflow plug with the engine idling.
Wait until the overflow slows to a trickle.
Remove the refill plug.
Refill the transmission through the refill hole until fluid begins to trickle out of the overflow tube.
Wait until the overflow slows to a trickle.
Install a new gasket and the overflow plug.
Install a new gasket and the refill plug.
| 6. COMPLETE |
Turn the ignition switch off.
Disconnect the Techstream from the DLC3.
![]() |
w/ Trailer Towing System (w/ Transmission oil cooler thermostat):
Remove the pin by pushing the shaft with a screwdriver.
Inspect for automatic transmission fluid leak.