DRIVE BELT > INSTALLATION |
| 1. INSTALL FAN AND GENERATOR V BELT |
![]() |
Set the V belt onto every part except the No. 2 idler pulley, as shown in the illustration.
Loosen the V belt by turning the belt tensioner counterclockwise.
Set the V belt to the No. 2 idler pulley.
![]() |
After installing the belt, check that it fits properly in the ribbed grooves.
Check by hand to confirm that the belt has not slipped out of the grooves on the bottom of the pulley.
![]() |
Check that the arrow on the belt tensioner is within area "A".
If it is outside area "A", replace the fan and generator V belt.
| 2. INSTALL AIR CLEANER HOSE ASSEMBLY |
![]() |
Install the air cleaner hose.
Connect the vacuum hose.
Connect the No. 2 ventilation hose.
| 3. INSTALL THROTTLE BODY COVER SUB-ASSEMBLY |
![]() |
Install the throttle body cover sub-assembly with the 2 nuts.
| 4. INSTALL NO. 1 ENGINE UNDER COVER |
![]() |
Hook the engine under cover onto the vehicle body as shown in the illustration.
Install the 3 screws and 5 bolts.