Home › ENGINE ยท 3UR-FBE › ENGINE MECHANICAL › REAR CRANKSHAFT OIL SEAL

REAR CRANKSHAFT OIL SEAL > REMOVAL

for Preparation Click here



1. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY
  1. Remove the automatic transmission (Click here).



2. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY


    A163778E02
  1. Using SST, hold the crankshaft.

    SST
    09213-70011  
    09330-00021  



    A163779
  1. Remove the 10 bolts, rear drive plate spacer, drive plate and crankshaft position sensor rotor.



3. REMOVE REAR CRANKSHAFT OIL SEAL
  1. Using a knife, cut off the lip of the oil seal.



    A163776E01
  1. Using a screwdriver, pry out the oil seal.

    HINT:
    Tape the screwdriver tip before use.

    NOTICE:
    Do not damage the surface of the oil seal press fit hole and crankshaft.