Home › ENGINE ยท 1GR-FE › ENGINE MECHANICAL › CYLINDER HEAD GASKET (for Bank 1)

CYLINDER HEAD GASKET (for Bank 1) > INSPECTION

for Preparation Click here



1. INSPECT CYLINDER HEAD SET BOLT


    A132794E03
  1. Using a vernier caliper, measure the outside thread diameter of the bolt.

    Measuring point:
    73.0 mm (2.87 in.)

    Standard outside diameter:
    10.85 to 11.0 mm (0.427 to 0.433 in.)

    Minimum outside diameter:
    10.7 mm (0.421 in.)

    HINT:
    If a visual check reveals no excessively thin areas, check the center of the bolt (see illustration) and find the area that has the lowest diameter.

    If the diameter is less than the minimum, replace the cylinder head bolt.



2. INSPECT CYLINDER HEAD SUB-ASSEMBLY


    A120705E03
  1. Using a precision straightedge and feeler gauge, measure the warpage of the contact surfaces of the cylinder block and manifolds.

    Standard warpage:
    Item
    Specified Condition
    Cylinder block side
    0.05 mm (0.00197 in.)
    Intake manifold side
    0.08 mm (0.00315 in.)
    Exhaust manifold side
    0.08 mm (0.00315 in.)

    Maximum warpage:
    Item
    Specified Condition
    Cylinder block side
    0.10 mm (0.00394 in.)
    Intake manifold side
    0.10 mm (0.00394 in.)
    Exhaust manifold side
    0.10 mm (0.00394 in.)

    If the warpage is greater than the maximum, replace the cylinder head sub-assembly.



    A075610E01
  1. Using a dye penetrant, check the intake ports, exhaust ports and cylinder surface for cracks.
    If there are cracks, replace the cylinder head sub-assembly.