Home › BODY ELECTRICAL › PARK ASSIST / MONITORING › INTUITIVE PARKING ASSIST SYSTEM

INTUITIVE PARKING ASSIST SYSTEM > Taillight Relay Circuit

for Preparation Click here


WIRING DIAGRAM


B144079E02


INSPECTION PROCEDURE

1.CHECK TAILLIGHT
  1. Turn the light control switch to the TAIL position.

  1. Check that the taillight turns on.

    OK:
    Taillight turns on.



NG
GO TO LIGHTING SYSTEM (Click here)
OK


2.CHECK HARNESS AND CONNECTOR (ECU - BATTERY)
B144569E03
  1. Disconnect the J35 ECU connector.

  1. Measure the voltage according to the value(s) in the table below.

    Standard voltage:
    Tester Connection
    Switch Condition
    Specified Condition
    J35-11 (TL) - Body ground
    Ignition switch ON,
    light control switch TAIL
    7 V or higher
    Ignition switch ON,
    light control switch except TAIL
    Below 1.5 V



NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
OK

PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (Click here)