Home › ENGINE ยท 1GR-FE › STARTING › STARTER (for 2.0 kW Type)

STARTER (for 2.0 kW Type) > DISASSEMBLY

for Preparation Click here



1. REMOVE STARTER YOKE ASSEMBLY


    A159744
  1. Remove the nut and disconnect the lead wire from the magnetic switch terminal.

  1. Remove the 2 through bolts.

  1. Pull out the starter yoke and the armature together.

  1. Remove the O-ring from the starter yoke.



2. REMOVE MAGNET STARTER SWITCH ASSEMBLY


    A074097
  1. Remove the 2 screws and magnet starter switch.



    A164761E01
  1. Remove the return spring, idler gear, clutch roller, retainer and starter clutch from the starter housing.



    ST00948E02
  1. Using a magnetic finger, remove the steel ball from the clutch shaft hole.



3. REMOVE STARTER BRUSH HOLDER ASSEMBLY


    A164437
  1. Remove the 2 screws and end cover from the starter yoke.

  1. Remove the O-ring from the starter yoke.



    A062429
  1. Using a screwdriver, hold the spring back and disconnect the 4 brushes from the brush holder.

  1. Remove the brush holder from the armature.



4. REMOVE STARTER ARMATURE ASSEMBLY
  1. Remove the starter armature from the starter yoke.