PARKING BRAKE SWITCH > ON-VEHICLE INSPECTION |
| 1. REMOVE PARKING BRAKE SWITCH ASSEMBLY |
![]() |
Remove the screw and switch.
| 2. CHECK PARKING BRAKE SWITCH ASSEMBLY |
![]() |
Measure the resistance according to the value(s) in the table below.
| Tester Connection | Switch Condition | Specified Condition |
| 1 - Body ground | Parking brake switch ON (Switch pin released) | Below 1 Ω |
| Parking brake switch OFF (Switch pin pushed in) | 10 kΩ or higher |
| 3. INSTALL PARKING BRAKE SWITCH ASSEMBLY |
![]() |
Install the switch with the screw.