Home › SUSPENSION & AXLE › SUSPENSION › REAR LEAF SPRING

REAR LEAF SPRING > INSTALLATION

for Preparation Click here


HINT:
  1. Use the same procedures for the RH side and LH side.
  2. The procedures listed below are for the LH side.
  3. A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL REAR SPRING SHACKLE BUSH


C159334
  1. Install the 2 shackle bushes to the frame.



2. INSTALL TUBE


C156237
  1. Install the tube to the bush.



3. TEMPORARILY INSTALL REAR SPRING ASSEMBLY LH


C156232E01
  1. Temporarily install the spring with the No. 2 spring shackle plate, shackle outer plate, 2 washers and 2 nuts to the rear side.



    C156231E01
  1. Temporarily install the spring with the bolt, washer and nut to the front side.



4. INSTALL REAR SPRING BUMPER SUB-ASSEMBLY


C159335E01
  1. Install the spring bumper.

    NOTICE:
    Align the leaf spring center bolt and nut with the installation hole of the rear axle housing and spring bumper so that they are not loose.



5. TEMPORARILY INSTALL REAR SPRING U BOLT


C156238E01
  1. Temporarily install the spring seat and 2 U bolts with the 4 washers and 4 nuts.

    NOTICE:
    1. Tighten the nuts in the order shown in the illustration.
    2. Install the U bolts so that the lengths of the 4 ends under the spring seat are the same.



6. CONNECT NO. 3 PARKING BRAKE CABLE ASSEMBLY


C156229E01
  1. Connect the parking brake cable to the vehicle with the 3 bolts.

    Torque:
    for Bolt A:
    19 N*m{ 194 kgf*cm , 14 ft.*lbf }
    for Bolt B:
    14 N*m{ 138 kgf*cm , 10 ft.*lbf }



7. STABILIZE SUSPENSION
  1. Lower the vehicle.

  1. Press down on the vehicle several times to stabilize the suspension.



8. TIGHTEN REAR SPRING ASSEMBLY LH
  1. Tighten the 3 nuts.

    Torque:
    105 N*m{ 1071 kgf*cm , 77 ft.*lbf }



9. TIGHTEN REAR SPRING U BOLT
  1. Tighten the 4 nuts.

    Torque:
    100 N*m{ 1020 kgf*cm , 74 ft.*lbf }



10. INSTALL REAR WHEEL

Torque:
for Aluminum Wheel:
131 N*m{ 1336 kgf*cm , 97 ft.*lbf }
for Steel Wheel:
209 N*m{ 2131 kgf*cm , 154 ft.*lbf }



11. INSTALL SPARE TIRE


12. REMOVE SAFETY STANDS