Home › STEERING › POWER STEERING › POWER STEERING GEAR

POWER STEERING GEAR > DISASSEMBLY

for Preparation Click here



1. FIX POWER STEERING GEAR ASSEMBLY


C159512E01
  1. Using SST, secure the power steering gear.

    SST
    09612-00012  

    HINT:
    Tape SST before use.

    NOTICE:
    When using a vise, do not overtighten it.



2. REMOVE TIE ROD END SUB-ASSEMBLY LH


C154516E01
  1. Put matchmarks on the tie rod end LH and steering rack end.



3. REMOVE TIE ROD END SUB-ASSEMBLY RH

HINT:
Use the same procedures described for the LH side.



4. REMOVE STEERING RACK BOOT CLIP
  1. Using pliers, remove the 2 steering rack boot clips.



5. REMOVE NO. 2 STEERING RACK BOOT CLAMP


C159523
  1. Using pliers, remove the 2 boot clamps as shown in the illustration.

    NOTICE:
    Be careful not to damage the No. 2 steering rack boot.



6. REMOVE NO. 2 STEERING RACK BOOT


7. REMOVE NO. 1 STEERING RACK BOOT