POWER STEERING GEAR > REASSEMBLY |
| 1. FIX POWER STEERING GEAR ASSEMBLY |
![]() |
Using SST, secure the power steering gear.
| 2. INSTALL NO. 2 STEERING RACK BOOT |
![]() |
Apply silicon grease to the inside of the small opening of the boot.
Install the No. 2 steering rack boot to the groove on the rack housing.
| 3. INSTALL NO. 1 STEERING RACK BOOT |
| 4. INSTALL NO. 2 STEERING RACK BOOT CLAMP |
![]() |
Using SST, tighten the 2 boot clamps as shown in the illustration.
| 5. INSTALL STEERING RACK BOOT CLIP |
![]() |
Using pliers, install the 2 boot clips.
| 6. INSTALL TIE ROD END SUB-ASSEMBLY LH |
![]() |
Align the matchmarks of the tie rod and rack end, and temporarily install the tie rod with the lock nut.
| 7. INSTALL TIE ROD END SUB-ASSEMBLY RH |