Home › ENGINE ยท 1GR-FE › EXHAUST › EXHAUST PIPE (except Regular Cab Standard Deck)

EXHAUST PIPE (except Regular Cab Standard Deck) > REMOVAL

for Preparation Click here


CAUTION:
  1. Wear protective gloves when removing the exhaust pipe.
  2. The exhaust pipe is extremely hot immediately after the engine has stopped.
  3. Confirm that the exhaust pipe has cooled down before removing it.



1. REMOVE TAILPIPE ASSEMBLY
  1. Remove the bolt and clamp.

  1. Disconnect the tailpipe from the exhaust pipe support.



2. REMOVE CENTER EXHAUST PIPE ASSEMBLY
  1. Remove the 4 bolts.

  1. Disconnect the center exhaust pipe from the 3 exhaust pipe supports.



3. REMOVE FRONT NO. 2 EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Remove the 3 nuts.

  1. Disconnect the front No. 2 exhaust pipe from the exhaust pipe support.



4. REMOVE FRONT EXHAUST PIPE ASSEMBLY
  1. Disconnect the air fuel ratio sensor connector.

  1. Disconnect the heated oxygen sensor connector.

  1. Detach the 2 heated oxygen sensor wire clamps.

  1. Remove the 3 nuts and front exhaust pipe.



5. REMOVE AIR FUEL RATIO SENSOR (for Bank 1 Sensor 1)


    A155871E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



6. REMOVE AIR FUEL RATIO SENSOR (for Bank 2 Sensor 1)


    A155867E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



7. REMOVE HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)


    A155873E01
  1. Using SST, remove the sensor.

    SST
    09224-00010  



8. REMOVE HEATED OXYGEN SENSOR (for Bank 2 Sensor 2)


    A155869E01
  1. Using SST, remove the sensor.

    SST
    09224-00010