Home › DRIVE LINE › JF1A TRANSFER › TRANSFER ASSEMBLY

TRANSFER ASSEMBLY > INSPECTION

for Preparation Click here



1. INSPECT TRANSFER INPUT SHAFT


    C159730
  1. Using a micrometer, measure the diameter of the input shaft journal surface.

    Minimum diameter:
    68 mm (2.68 in.)

    If the diameter is less than the minimum, replace the input shaft.



    C159731
  1. Using a dial indicator, measure the inside diameter of the input shaft bush.

    Maximum inside diameter:
    46 mm (1.81 in.)

    If the inside diameter is greater than the maximum, replace the input shaft.



2. INSPECT TRANSFER LOW PLANETARY GEAR ASSEMBLY


    C159732
  1. Using a feeler gauge, measure the thrust clearance of the pinion gear.

    Standard clearance:
    0.11 to 0.85 mm (0.00437 to 0.0335 in.)

    Maximum clearance:
    0.85 mm (0.0335 in.)

    If the clearance is greater than the maximum, replace the low planetary gear assembly.



3. INSPECT TRANSFER LOW PLANETARY GEAR ASSEMBLY


    C159733
  1. Using a dial indicator, measure the radial clearance of the pinion gear.

    Standard clearance:
    0.011 to 0.038 mm (0.000354 to 0.00150 in.)

    Maximum clearance:
    0.038 mm (0.00150 in.)

    If the clearance is greater than the maximum, replace the low planetary gear assembly.



4. INSPECT REAR TRANSFER OUTPUT SHAFT


    C159737E01
  1. Using a micrometer, measure the diameter of the output shaft journal.

    Minimum diameter:
    Journal
    Specified Condition
    A
    40 mm (1.58 in.)
    B
    49 mm (1.93 in.)

    If the diameter is less than the minimum, replace the output shaft.



5. INSPECT NO. 1 TRANSFER GEAR SHIFT FORK AND HUB SLEEVE


    C159728
  1. Using a feeler gauge, measure the clearance between the clutch sleeve and gear shift fork.

    Maximum clearance:
    2.1 mm (0.0827 in.)

    If the clearance is greater than the maximum, replace the clutch sleeve or shift fork.



6. INSPECT NO. 2 TRANSFER GEAR SHIFT FORK AND HUB SLEEVE


    C159729
  1. Using a feeler gauge, measure the clearance between the clutch sleeve and gear shift fork.

    Maximum clearance:
    1.0 mm (0.0394 in.)

    If the clearance is greater than the maximum, replace the clutch sleeve or shift fork.