Home › ENGINE ยท 3UR-FBE › EMISSION CONTROL › CANISTER

CANISTER > REMOVAL

for Preparation Click here



1. REMOVE CANISTER ASSEMBLY


    A147034
  1. Remove the nut and disconnect the wire harness clamp bracket.



    A155876E01
  1. Disconnect the connector.

  1. Disconnect the purge line hose.

  1. Disconnect the air inlet line hose.

    1. Push the hose firmly toward the canister side.

    2. Pinch the hose (portion A) as shown in the illustration.

    3. Pull out the hose.

      NOTICE:
      1. Do not use any tools in this procedure.
      2. Check for any dirt and foreign matter contamination in the canister and around the hose. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the canister and hose.

  1. Disconnect the vent line hose.

    1. Pinch the retainer and then raise it.

      NOTICE:
      1. Do not use any tools in this procedure.
      2. Check for any dirt and foreign matter contamination in the valve and around the connector. Clean if necessary. Foreign matter may damage the O-rings or cause leaks in the seal between the valve and connector.



    A147033
  1. Disconnect the wire harness clamp.



    A147035
  1. Remove the 4 bolts and canister.