Home › SERVICE SPECIFICATIONS › SERVICE SPECIFICATIONS › 1GR-FE ENGINE CONTROL SYSTEM

1GR-FE ENGINE CONTROL SYSTEM > TORQUE SPECIFICATIONS



Part Tightened
N*m
kgf*cm
ft.*lbf
Camshaft timing oil control valve assembly x Cylinder head
10
102
7
VVT sensor x Cylinder head
8.0
82
71 in.*lbf
Crankshaft position sensor x Cylinder block
10
102
7
Engine coolant temperature sensor x Rear water by-pass joint
20
204
15
Throttle body x Intake manifold
11
112
9
No. 1 Water outlet pipe x Cylinder block
10
102
7
Knock sensor x Cylinder block
20
204
15
ECM x Body
8.0
82
71 in.*lbf
Connector holder block x Body
7.3
74
65 in.*lbf
Accelerator pedal rod assembly x Body
5.0
51
44 in.*lbf
Air fuel ratio sensor x Front exhaust pipe assembly
(for Bank 1 Sensor 1)
44 (40)
449 (408)
32 (30)
Air fuel ratio sensor x Front No. 2 exhaust pipe assembly
(for Bank 2 Sensor 1)
44 (40)
449 (408)
32 (30)
Heated oxygen sensor x Front exhaust pipe assembly
(for Bank 1 Sensor 2)
44 (40)
449 (408)
32 (30)
Heated oxygen sensor x Front No. 2 exhaust pipe assembly
(for Bank 2 Sensor 2)
44 (40)
449 (408)
32 (30)
( ): For use without SST