FRONT SEAT OUTER BELT ASSEMBLY (for Center Seat) > INSTALLATION |
| 1. INSTALL CENTER FRONT SEAT BELT ASSEMBLY RH |
![]() |
Align the seat frame's claws with the seat belt retractor positioning holes.
Install the seat belt with the nut and bolt.
| 2. INSTALL FRONT SEAT HEADREST SUPPORT |
![]() |
Attach the 4 claws to install the 2 headrest supports.
| 3. INSTALL FRONT SEATBACK BOARD SUB-ASSEMBLY |
![]() |
RH Side:
Connect the cable to the center seatback frame inner side.
![]() |
LH Side:
Connect the cable to the center seatback frame inner side.
![]() |
Attach the 21 claws to install the board.
Install the screw.
![]() |
Install the 6 screws.
| 4. INSTALL SEAT FASTENER COVER |
![]() |
Attach the 6 claws to install the 2 covers.
| 5. INSTALL CENTER FRONT SEAT ARMREST COVER |
![]() |
Install the armrest cover with the 2 screws.
| 6. INSTALL FRONT SEAT TRAY |
![]() |
Attach the 5 clips to install the tray.
| 7. INSTALL RECLINING REMOTE CONTROL BEZEL |
![]() |
Attach the 2 clips and claw to install the bezel.
| 8. INSTALL LOWER FRONT SEAT SHOULDER BELT COVER |
![]() |
Using a T30 "TORX" socket, install the shoulder belt cover with the 2 bolts.
| 9. INSTALL UPPER REAR SEATBACK LOCK BEZEL |
![]() |
Connect the seat belt to the shoulder belt cover.
Attach the 4 claws to install the lock bezel.
| 10. INSTALL FRONT SEAT SHOULDER BELT COVER |
![]() |
Using a T10 "TORX" socket, install the shoulder belt cover with the 2 screws.
| 11. INSTALL FRONT SEAT HEADREST ASSEMBLY |
| 12. INSTALL CENTER SEATBACK ASSEMBLY |
![]() |
Install the center seatback.
RH Side:
Using a T55 "TORX" socket, install the 2 bolts.
LH Side:
Using a T40 "TORX" socket, install the 2 bolts.
![]() |
Install the 2 wire harness clamps to the center seatback frame.
| 13. CONNECT CENTER FRONT SEAT BELT ASSEMBLY RH |
![]() |
Install the belt anchor with the bolt.
| 14. INSTALL CENTER SEAT CUSHION SHIELD RH |
![]() |
Attach the 7 claws and 3 clips to install the cushion shield.
Using a T30 "TORX" socket, install the bolt.
| 15. INSTALL CENTER SEAT CUSHION SHIELD LH |
![]() |
Attach the 7 claws and 2 clips to install the cushion shield.
Using a T30 "TORX" socket, install the bolt.
| 16. INSTALL CENTER FRONT SEAT ASSEMBLY |
Install the front seat .
| 17. INSTALL FRONT SEAT ASSEMBLY (for Power Seat) |
Install the front seat (Click here).
| 18. INSTALL FRONT SEAT ASSEMBLY (for Manual Seat) |
Install the front seat (Click here).