SLIDING ROOF HOUSING (for CrewMax) > REASSEMBLY |
| 1. INSTALL REAR SLIDING ROOF HOUSING MOUNTING BRACKET LH |
![]() |
Install the mounting bracket with the 2 bolts.
| 2. INSTALL REAR SLIDING ROOF HOUSING MOUNTING BRACKET RH |
| 3. INSTALL SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY |
Hold down the window deflector.
![]() |
![]() |
Using a screwdriver, slide the drive cable in the direction indicated by the arrow in the illustration to install it.
![]() |
Slide each roof wind deflector lifter link in the direction indicated by the arrow in the illustration to install it, then attach the claw.
![]() |
Attach the 4 claws to install the 4 roof wind deflector panel guide clips.
![]() |
Attach the 2 claws to install the drip channel.
| 4. ADJUST SLIDING ROOF DRIVE CABLE SUB-ASSEMBLY |
![]() |
Using a screwdriver, align the matchmarks by sliding the drive cable in the directions indicated by the arrow in the illustration.
| 5. INSTALL SUNSHADE TRIM SUB-ASSEMBLY |
![]() |
Insert the sunshade trim into the sliding roof housing.
Attach the 4 claws to install the sliding roof piece LH and RH.
Install the 2 screws.
| 6. INSTALL SLIDING ROOF DRIVE GEAR SUB-ASSEMBLY |
![]() |
Install the drive gear and room light bracket with the 2 bolts.