Home › BODY › ENGINE HOOD / DOOR › HOOD LOCK CONTROL CABLE ASSEMBLY

HOOD LOCK CONTROL CABLE ASSEMBLY > INSTALLATION

for Preparation Click here


HINT:
A bolt without a torque specification is shown in the standard bolt chart (Click here).



1. INSTALL HOOD LOCK CONTROL CABLE ASSEMBLY
  1. Pass the cable into the engine room.

  1. Pass the cable rear side through the grommet until the cable stopper is attached to the grommet.

  1. Pass the cable front side through the upper radiator support.



  1. Attach the cable to the clamps as shown in the illustration.


    B166024E01



2. INSTALL HOOD LOCK CONTROL LEVER SUB-ASSEMBLY


    B166023
  1. Connect the hood lock control cable to the hood lock lever.

  1. Attach the 2 claws to install the hood lock lever



3. INSTALL HOOD LOCK ASSEMBLY


    B166025
  1. Apply MP grease to the sliding areas of the lock.



    B166022
  1. Connect the hood lock control cable.

  1. Install the hood lock.

  1. Install the 2 bolts and nut.

    Torque:
    8.0 N*m{ 82 kgf*cm , 71 in.*lbf }

  1. Install a new cap.

  1. w/ Theft Deterrent System:
    Connect the connector.



4. INSTALL HOOD LOCK CONTROL CABLE COVER


    B167796
  1. Attach the clamp to install the cable cover.

  1. Install the screw and nut.