REAR DOOR (for Double Cab) > ON-VEHICLE INSPECTION |
| 1. INSPECT REAR DOOR PANEL SUB-ASSEMBLY LH |

Check that the clearance measurements of areas A to J are within the standard range.
| Area | Specified Condition | Area | Specified Condition |
| A | 4.7 to 7.7 mm (0.185 to 0.303 in.) | F | 2.5 to 5.5 mm (0.0984 to 0.217 in.) |
| B | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) | G | 3.5 to 6.5 mm (0.138 to 0.256 in.) |
| C | 3.2 to 6.2 mm (0.126 to 0.244 in.) | H | -1.4 to 1.6 mm (0.0551 to 0.0630 in.) |
| D | 2.7 to 5.7 mm (0.106 to 0.224 in.) | I | 4.0 to 7.0 mm (0.156 to 0.277 in.) |
| E | 3.2 to 6.2 mm (0.126 to 0.244 in.) | J | -1.1 to 1.9 mm (-0.0433 to 0.0748 in.) |