REAR DOOR (for CrewMax) > ON-VEHICLE INSPECTION |
| 1. INSPECT REAR DOOR PANEL SUB-ASSEMBLY LH |

Check that the clearance measurements of areas A to J are within the standard range.
| Area | Specified Condition | Area | Specified Condition |
| A | 4.7 to 7.7 mm (0.185 to 0.303 in.) | F | 0.7 to 3.7 mm (0.0276 to 0.146 in.) |
| B | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) | G | 3.7 to 6.7 mm (0.146 to 0.264 in.) |
| C | 3.7 to 6.7 mm (0.146 to 0.264 in.) | H | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |
| D | 0.8 to 3.8 mm (0.0315 to 0.150 in.) | I | 3.7 to 6.7 mm (0.146 to 0.264 in.) |
| E | 3.7 to 6.7 mm (0.146 to 0.264 in.) | J | -1.5 to 1.5 mm (-0.0591 to 0.0591 in.) |